Android Universal TV board MSD338STV5.0 installing process.#Pro Hack
Articles,  Blog

Android Universal TV board MSD338STV5.0 installing process.#Pro Hack


welcome back to Pro Hack today I am
talking about smart Universal motherhood driver install process it has a little
driver installing process difference from the other general motherboard
driver has entered in the pen drive the driver is longer than normal drivers so
wait few time press on power bottom
as long as a little blinking start lighting wait few times when led is become standby the
driver installing will be finished connect LVDS supply and backlight supply service menu factory is source 2,5.8, important setting in the panel info Ti Mode,Bit Mode. thank you for watching this video stay
with us for new upcoming videos

25 Comments

  • Family days

    hello guys, I would like to know if you know if this 1440×900 LCD card is useful since I have seen that the firmware reset of 1g says no 1440×900 and effectively when I charge this reset with 1g if it shows full screen but with logo, but in logo it Actor, when I do it with the reset of 512 and the same firmware loads everything, but the screen is out of focus the mita, it does not appear full screen, I hope you can give me a solution, I will be aware of the answers thanks.

  • BIGS SCORE

    can I ask you a question I'm in England and we use DVB TV -2 , do you think I can connect a USB TV dongle to the Android to watch TV???because the on-board chip and this unit does not support uk tv dvb2 so I was gonna use my phone dongle USB that I watch tv on my Android on my phone, can i connect this to MSD338STV5.0 Android do you think???

  • Alexander Lopez Cardozo

    good morning friend

    Do you know how to unlock it?

    I installed a firmware and it was blocked

    I turn on the power, turn on the red LED for a moment and do nothing more

  • BIGS SCORE

    Hello please can I ask you a question, I want to use this for a laptop with a 3.3v led backlight, I have noticed that this board only supplies a 5 volt and a 12 volts supply and it dos not have a 3.3v, can I use a Buck converter to reduce the voltage to 3.3 from either 5 volts or 12 volts supply on the bord????

  • BIGS SCORE

    Hello please can I ask you a question, I want to use this for a laptop with a 3.3v led backlight, I have noticed that this board only supplies a 5 volt and a 12 volts supply and it dos not have a 3.3v, can I use a Buck converter to reduce the voltage to 3.3 from either 5 volts or 12 volts supply on the bord????

  • BIGS SCORE

    In your comment you say if you've got a question drop me a line, I've asked you a question twice now and all you do is give me a thumbs up, what kind of idiot are you give a thumbs up twice idiot, how can you make a video and you can't be bothered to read the comments.

  • BIGS SCORE

    in your comment you say if you've got a question drop me a line, I've asked you a question twice now and all you do is give me a thumbs up, what kind of idiot are you. how can you make a video and you can't be bothered to make a reading comments. I suppose you're going to give me another thumbs up without reading my question idiot.

  • Mark Home Studio

    I am looking for software for the GZGT_MSD338-V5.0_DTMB_512M_4G 1600×900 model
    Please help me. Firmware is model 1G not suport.

Leave a Reply

Your email address will not be published. Required fields are marked *